The sE1a, An Affordable, Small Diaphragm, High Performance Condenser Microphone.
sE Electronics sE1a condenser microphone brings remarkable vocal recording performance to the table at a much lower cost then you might expect. The sE1a cuts these costs down through the avoidance of unnecessary sliders and side controls. As this small yet surprisingly powerful microphone can handle up to a massive 137db of sound pressure, it can easily withstand the loudest guitar amplifiers without a hitch.
Great for strings, acoustic guitars and pianos, the sE1a uses a capsule built and tested by the same skilled technicians as the more expensive sE5 and Rupert Neve Signature RN17 SDCs, housed in a chassis alongside super-quiet electronics.
Even though the sE1a does not include any pads or roll-off switches - which helps keep costs down - you won't miss them. It can handle a massive 137dB sound pressure level, which is more than enough for the loudest drums and guitars. No frills, no switches...no need for them.
- Frequency Response: 30Hz-20KHz
- Sensitivity: 10mV/Pa - 40 ± 2dB(0dB=1V/Pa 1000Hz)
- Polar Pattern: Cardioid, Diversity
- Impedance: 300 Ohms
- Equivalent Noise Level: 17dB(A weighted)
- Max SPL for 0.5% THD@1000Hz: 137dB
- Power Requirement: Phantom power 48V±4V
- Connector: 3-pin
|Applications||acoustic guitar, strings, piano, cymbals, hats, overhead drums|
We constantly monitor our competitors' prices to ensure that we're the best. However if you do find it cheaper, you can request an instant price match during opening hours by completing the form below.
*Please note that Terms & Conditions apply to Price Match - Must be a UK-based seller with the item In Stock, and is not available in conjunction with Finance or other Offers*